Star Headlight & Lantern STAR-PA RSK996P - Manual (Page 4)

-2-
Mounting
Mount the pack on a smooth metal surface to allow for adequate heat dissipation. Do not
mount the pack near any external heat source, as this will retard its ability to dissipate heat
sufficiently. Mount the pack using four bolts (not included). When mounting, make sure a
good electrical connection exists between the mounting plate and the vehicle chassis. This
will help to eliminate any RF interference.
5
1
2
"
2
1
2
"
STAR-PAK
STROBE POWER SUPPLY
RP966/RP996 PATTERN
SELECT
POS 1
POS 2
POS 1 1+2 3+4 5+6
LOW
STROBE HEADS
ENABLE
FUSE
POWER
1-2 3-4 5-6
P
-
+
A
B
C
I
15
I
STATUS
4
3
4
" 4
1
4
"
POS 2 1 _ 4 5+6
HI
A B C
R
+
+
+
3
16
" DIA.
When mounting the power pack and accessories, please be sure to
keep any radio frequency sensitive equipment at l east 20” from the
power pack, cables, and/or wires which make up your strobe system.
The pack has been designed to limit RFI emissions, but certain very
sensitive equipment may still be affected. Symptoms may include,
but are not limited to, sporadic operation and degraded performance.
Star Headlight & Lantern Co., Inc. cannot assume any responsibility
for any radio frequency induced malfunction or damage to any
radios, sirens, lightbars, or any other equipment mounted within 20”
of this strobe system. Any antennae mounted in the proximity of the
system may cause your radio to suffer the aforementioned results.