Star Headlight & Lantern ULB44-TD Star Phantom Undercover - Manual (Page 3)

-2-
P30073-4 (QTY=4)
#8 FLAT WASHERS
Mounting (CONT'D)
1. Insert a carriage bolt through one of the
1/4” washers and slide it through the back
of each of the long L-brackets. Please
note that washer is used as a spacer on
the square neck of the carriage bolt.
2. Remove the four of the #8 Phillips head screws shown to the
right from the light and add the # 8 washers. Use them to
install the long L-brackets.
CAUTION: Take extreme caution not to over
tighten the screws!!!
Corner Post Brackets
Forked Brackets
This light is designed to be mounted in the rear window of a vehicle using both the forked
brackets and the corner post brackets. Failure to use both brackets could result in a
faulty mount and will void the warranty. If your vehicle is not compatible with these
brackets you must custom design mounting brackets
.
FORKED BRACKET INSTALLATION
Before beginning the installation:
• Determine where the Traffic Director is to be mounted.
• Ensure there are no obstructions hindering the visibility of your traffic director.
• Select a location to mount your controller that is dry, out of direct sunlight, and free of
dirt and dust. Under the vehicle's instrument panel is usually the best choice.
• Determine the path your cable, which connects the controller to the Traffic Director,
will take. The cable should exit the left side of the Traffic Director when you are
facing both the lightbar and the controller.
Be sure the cable attached to your Traffic Director is long enough for proper installation.
If it is too short, you will need to order a Traffic Director with the correct length cable pre-
installed. The standard length for the cables is 15'. Star does not recommend
“splicing in” additional cable when the supplied cable is too short. Traffic Directors
with 30', 45' and 60' cables are available upon request.