Star Headlight & Lantern ULB44-TD Star Phantom Undercover - Manual (Page 7)

-6-
(Wiring CONT’D)
Wiring for Optional Automatic Activation
1. The Traffic Director may also be wired to automatically bypass the ULB42-TD--2 controller On/
Off switch and turn on through the use of an alternate power source (i.e. lightbar switch, siren
switch, reverse switch, etc.).
2. When you apply +12VDC
to the 12AWG wire
supplying the stick with
power, you will bypass the
On/Off switch and activate
the Traffic Director. When
activated, the Traffic
Director will automatically
enter the "Warn" pattern.
Operation
Important: This product is used to direct traffic. Improper use may
result in vehicular collision, personal injury and/or death. Star
Headlight & Lantern Co., Inc., and its subsidiaries shall not be held
responsible for damages directly or indirectly caused by improper
use of this product. Always carefully consider the effect on traffic
that the selected light pattern will have before engaging the lights.
ULB42-TD-2 Controller
1. Operation of your Traffic Director is straightforward. The controls include an On/Off
switch, four Pattern Select buttons, and three additional "option" buttons.
2. When the On/Off switch is activated, the traffic director will automatically go into the
WARN pattern. The LED display should show the "WARN” pattern and the WARN label
should glow red.
3. Select the desired pattern (if different from
the current pattern) by using any of the
Pattern Select buttons. The Pattern Select
buttons include Left, Center, Right, and
Warn. The selected pattern label should
change to red and the roof display should
mimic exactly the display on the controller.