Desa CGD3924NR - Manual (Page 18)

18
103343
3
INSTALLING
Continued WARNING
Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this heater may result in
property damage or personal injury.
INSTALLING LOGS
Each log is marked with a number. These numbers will help you identify the log
when installing. It is very important to install these logs exactly as instructed. Do
not modify logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in
the grate base behind the burner (see Figure 15).
2. Place the base of the middle log (#2) in the U-shaped slots of the grate base in front
of the back log. The cutout on the right of the middle log should fit over the burner
(see Figure 16). Make sure the front of the middle log is resting on the tabs of the
grate base and the cutout area is centered over the burner “U” bend.
3. Locate the recesses on the back of the front log (#3). Fit these recesses between
the posts of the grate base (see Figure 17).
4. Locate the notches in the bottom of the crossover log (#4). Place the crossover
log on top of the middle log and front log. Make sure the notches of the cross-
over log lines up with rectangular knobs on top of the middle and front logs
(see Figure 18).
Figure 15 - Installing Back Log (#1) Figure 16 - Installing Middle Log (#2)
Figure 17 - Installing Front Log (#3) Figure 18 - Installing Crossover
Log (#4)
Peg
Hole in
Grate Base
Back Log (#1)
Burner
Cutout
Tab
U-Shaped
Slot
Middle Log (#2)
Crossover
Log (#1) Notches
Rectangular
Knobs
“U” Bend
Front Log (#3)
Recess
Post
Post