SurgeX SX-AX20E - Manual (Page 22)

User Manual
Firmware Version v2.04.281
© 2015 SurgeX/Electronic Systems Protection, Inc. | Technical Support: 800-645-9721 | surgex.com 22
6.5 Device Commands
Command Description Admi Fact Def
get outlet <1 ‐10>
Returns the status of the specified outlet. AC outlets are numbers 1-8. Aux Relays
A and B are numbers 9 and 10.
No
set outlet <1 ‐10> <on/off/reboot>
Sets the selected outlet to the selected state. The user must have rights to
the selected
No
get devicename Returns the device name. No Axess ELITE
set devicename <devicename> Sets the device name. Yes
get reboot Returns the Reboot Time. No
set reboot <1-99> Sets the Reboot Time in seconds. No 5
get delay Returns the Delay Time. No
set delay <0-99> Sets the Delay Time in seconds. No 1
get console Returns the current console timeout and baud rate. No
set autologout <0-99> Sets the automatic logout timeout of web and CLI in minutes. 0 = no timeout. Yes 2
set baud < 2400 | 9600 | 57600 | 115200 > Sets the serial port baud rate. Yes 9600
clear shutdown Clears a persistent shutdown state. No
set clear shutdown by user < yes | no > Sets the ability of a user account to clear a persistent shutdown state. Yes Y
get upload enable Returns the status of the ability to accept a firmware upload. No
set upload enable < yes | no > Sets the ability to accept a firmware upload. Yes Y
clear log Clears history text log file. Yes
set factory defaults Resets all parameters, except Network Settings, to their factory default settings.
Confirmation is required. Note: This command may take up to 30 seconds to execute.
Yes
logout Ends the session. No
reboot Reboots the unit. Will not affect the status of the outlets. No