SurgeX SX-AX20E - Manual (Page 29)

User Manual
Firmware Version v2.04.281
© 2015 SurgeX/Electronic Systems Protection, Inc. | Technical Support: 800-645-9721 | surgex.com 29
eType_Commands
Commands are used to control and query the managed device.
typedef enum {
eCommands_null,
eCommands_setOutletStatus,
eCommands_getOutletStatus,
eCommands_getOutletCurrent,
eCommands_getOutletPower,
eCommands_setAuxRelayStatus,
eCommands_getAuxRelayStatus,
eCommands_getLineVoltage,
eCommands_getLineCurrent,
eCommands_getLinePower,
eCommands_getSysStatus,
eCommands_poll
}eCommands;
Command Description Payload Response
eCommands_null This is a null command and should
not be used. None None
eCommands_setOutletStatus This command is used to control an
individual outlet. Note: The inform returned
as a result of the command will reflect the
current outlet state, and will not reflect the
requested change. tOutletCommand eInforms_OutletStatus
eCommands_getOutletStatus This command is used to get the
status of all outlets. None eInforms_OutletStatus
eCommands_getOutletCurrent This command is used to get the
current draw of all outlets (Amps). None eInforms_OutletCurrent
eCommands_getOutletPower This command is used to get the
power draw of all outlets (Watts). None eInforms_OutletPower
eCommands_setAuxRelayStatus This command is used to set the
status of the selected Aux Relay. tOutletCommand eInforms_AuxRelayStatus
eCommands_getAuxRelayStatus This command is used to get the
status of both Aux Relays. None eInforms_AuxRelayStatus
eCommands_getLineVoltage This command is used to get the line
voltage (AC Volts). None eInforms_LineVoltage
eCommands_getLineCurrent This command is used to get the total
line current (Amps). None eInforms_LineCurrent
eCommands_getLinePower This command is used to get the total
power draw (Watts). None eInforms_LinePower
eCommands_getSysStatus This command is used to get the
system status. None eInforms_sysStatus
eCommands_poll This command is used to poll
Expansion units. None eInforms_poll