SurgeX SX-AX20E - Manual (Page 33)

User Manual
Firmware Version v2.04.281
© 2015 SurgeX/Electronic Systems Protection, Inc. | Technical Support: 800-645-9721 | surgex.com 33
Exit: Exits the DMU program
Help: Online Help: Opens a web browser to online help resources
About: Displays DMU version information
11. Syslog
The Axess Elite contains a built in Syslog client. When enabled, it will send Syslog formatted UDP messages on port 514.
Messages will be sent for the following System Triggers:
 Over-Voltage Auto Shutdown Trigger
 Over-Voltage Auto Shutdown Clear
 Under-Voltage Auto Shutdown Trigger
 Under-Voltage Auto Shutdown Clear
 Over-Current Auto Shutdown Trigger
 Over-Current Auto Shutdown Clear
 Over-Temperature Auto Shutdown Trigger
 Over-Temperature Auto Shutdown Clear
 Self-Test Failure Auto Shutdown Trigger
 Self-Test Failure Auto Shutdown Clear
Example:
12. Rear Panel Reset Button
The recessed reset pushbutton located on the rear panel to the right of the Network connection performs three functions:
Reboot, Password Reset, and Factory Default Reset.
Pressing the reset button once quickly will reboot the Axess Elite. The outlets will be set to the states specified by their
Initial State parameters. This operation will also clear a Persistent Shutdown State.
Holding the reset button for 5 seconds or longer will initiate a recovery mode. Once the reset button is released, the user
has 30 seconds to log in to the CLI using the username admin and password admin. After logging in during recovery
mode, the command set password <password> may be used to assign a new admin password. While in this mode, the
red Mains LED will flash 0.5 seconds on/off.
Holding the reset button for 5 seconds or longer while powering up the unit will enter factory default reset mode. When the
button is released, the unit will be reset to factory defaults, including Network Settings.
13. Firmware Upgrade
Refer to the Firmware Upgrade Utility user manual at http://www.surgex.com/products/Axess-ELITE.html for details
02-24-2012 13:55:14 System4.Alert 10.1.2.69
02/24/2012 13:55:15 Cabinet_1 System Trigger Over Temperature Alarm