Velodyne SMS-1 - Manual (Page 39)

www.velodyne.com Digital Drive SMS-1 User’s Manual - 33
2. Raise the volume of the SMS-1 after you have finished your room equalization and other
settings. You can observe this difference by watching the “SYSTEM RESPONSE” graph as you
raise the volume, or,
Of course, all hearing is different, so be sure to perform the above step “to taste”. Your setup is complete! You
are now ready to save settings. You can press the EXIT button on the remote, or position the cursor over the
SAVE/EXIT field on the screen and press select. The system responds with the following screen:
3. Raise the volume on your subwoofer.
Of course, all hearing is different, so be sure to perform the above step “to taste.” 25. Your setup is complete!
You are now ready to save settings. You can press the EXIT button on the remote, or position the cursor over
the SAVE/EXIT field on the screen and press select. The system responds with the following screen:
By pressing the SelecT button, you tell the system to save your settings and return to the introduction screen.
Selecting NO returns without saving (i.e. whatever previous settings were in effect will be used), and CANCEL
keeps you in setup mode.
When the unit saves settings, you will see the video flicker and you may hear a slight tick in your main speakers.
This is normal behavior.
NOTE: The digital drive SmS-1 stores all of its settings in internal “Flash” memory. This memory persists even if
the SMS-1 is turned off, loses power, or undergoes a programming update, so you need not worry about losing
your customized settings.