Velodyne WiConnect - Manual (Page 10)

www.velodyne.com 4 - WiConnect User’s Manual
A. cHAnnel: Select broadcast frequency. This cHAnnel selection must match cHAnnel selection on
the transmitter.
B. LFE INPUT: Optional wired connection to receiver, if not using the wireless connection.
c. PHASE: Invert the phase of the subwoofer, if it blends better with the satellite speakers.
d. LOW-PASS CROSSOVER: Select the upper frequency to cut-off the audio signal to the subwoofer
output.
e. ACTIVE:
• Solid yellow when ON/ACTIVE using wireless connection.
• Flashing yellow and green when ON/ACTIVE , but no RF signal.
• Solid Red when in ON/STAND BY.
• Subwoofer goes to STAND BY if no audio signal is present for 12 minutes.
F. VOLUME: Adjust subwoofer volume.
G. POWER: Switch power On and OFF.