Velodyne WiConnect - Manual (Page 11)

www.velodyne.com WiConnect User’s Manual - 5
Connect Wireless Transmitter to Receiver
Use one of the following two setups to connect the wireless transmitter to receiver:
SETUP #1: MOST COMMON (RECEIVER LFE/SUB OUTPUT) This setup requires one RCA cable
SETUP #2: LESS COMMON (NO RECEIVER LFE/SUB OUTPUT) This setup requires one RCA cable for each
of the l and R channels.
SETUP #1: MOST COMMON (RECEIVER HAS LFE/SUB OUTPUT)
1. Use the RcA cable supplied by you to connect the wireless transmitter’s lFe input to your receiver’s lFe
or SUB output.
2. Plug the wireless transmitter’s 5V dc power adaptor into the back of the wireless transmitter. Plug the
other end of the adaptor into a power outlet.
3. Go to the Select Receiver Options for Optimal Subwoofer Performance instructions next.
NOTE: The subwoofer must be within 50 feet (15 meters) from its transmitter to be able to receive the
wireless signal. Also, make sure that the same cHAnnel is selected on both the transmitter and subwoofer.