Vortech 2003-2004 Mustang Mach 1 - Manual (Page 37)

P/N: 4FR020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
23AUG04 86-93 4V Mus. Cobra(4FR v3.1)
P/N: 4FR020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
23AUG04 86-93 4V Mus. Cobra(4FR v3.1)
25
10. AIR INLET, cont'd
Fig. 10-i / Modified Shaker Bracket
(Mach 1 Models Only)
FRONT VIEW AFTER
MODIFICATION
USE THE BRACKET PROVIDED
AS A TEMPLATE AND
DRILL 2 Ø5/16" HOLES
DRIVER SIDE VIEW
AFTER MODIFICATION
THIS PORTION REMOVED
AND DISCARDED
.50
2.25 1.75
Fig. 10-j / Bracket mods (Mach 1 Only)
3. Modify the steel air scoop base mount as
shown. (See Figs. 10-i, 10-j.) A bandsaw is
the best tool to use. An abrasive cut-off wheel
or hacksaw may also be used.
4. Temporarily place the modified steel air scoop
base into its factory location on top of the
intake manifold. Loosely install the two factory
screws that secure the rear of the bracket to
the intake manifold (do not tighten at this time).
The two supplied relocation brackets must be
attached to the modified steel scoop base.