Vortech 2003-2004 Mustang Mach 1 - Manual (Page 41)

P/N: 4FR020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
23AUG04 86-93 4V Mus. Cobra(4FR v3.1)
P/N: 4FR020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
23AUG04 86-93 4V Mus. Cobra(4FR v3.1)
13. FINAL CHECK
A. Reconnect the battery.
B. If your vehicle has gone over 20,000 miles since
its last spark plug change, you will need to
change the spark plugs now before test driving
the vehicle.
C. Check all fittings, nuts, bolts and clamps for
tightness. Pay particular attention to oil and fuel
lines around moving parts, sharp edges and
exhaust system parts. Make sure all wires and
lines are properly secured with clamps or tie
wraps.
D. Double check water pump pulley bolts for
tightness.
E. Check all fluid levels, making sure that your tank(s)
is/are filled with 91 octane or higher fuel before
commencing test drive.
F. Start the engine and allow to idle a few minutes,
then shut off.
G. Recheck to be sure that no hoses, wires, etc. are
near exhaust headers or moving parts and for
signs of any fluid leakage. (See Fig. 13-a.)
H. PLEASE TAKE SPECIAL NOTE: Operating the
vehicle without ALL the subassemblies completely
and properly installed may cause FAILURE OF
MAJOR COMPONENTS.
I. Test drive the vehicle.
J. Read the STREET SUPERCHARGER SYSTEM
OWNER'S MANUAL AND RETURN THE
COMPLETED WARRANTY REGISTRATION
FORM within thirty (30) days of purchasing your
supercharger system .
Fig. 13-a
29
WARNING: Do not attempt to operate the vehicle
until ALL components are installed and
ALL operations are completed including
the final check.
NOTE: Once the ECM is recieved back from
Vortech with the ECM module installed,
reinstall the ECM into the vehicle. In some
cases, the extra height of the ECM mod-
ule will not allow the use of the factory
hold-down bracket. Reconnect the factory
harness and reinstall the factory kick panel.