Vortech GM 5.3L/6.2L Light Truck/SUV - 2007-2008 - Manual (Page 21)

P/N: 4GL020-018
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
11NOV08 GM Trk/H2(4GL..018v2.0)
11
9. SUPERCHARGER BYPASS INSTALLATION
A. Connect the 4" length of Ø1" hose from the
barb on the supercharger inlet duct to the out-
let of the bypass valve.
B. Cut the supplied molded hose as shown in
Fig. 9-a.
C. Using the supplied #16 hose clamps, connect
the barb on the discharge duct to the inlet of
the bypass valve using the previously cut Ø1"
molded hose. (See Fig. 9-b.)
CUT AND
DISCARD
Fig. 9-a
Fig. 9-b
Fig. 9-c
NOTE: Some vehicles may require trimming of the engine cover to
clear various components. If necessary, trim the cover to clear
the bypass valve hose.
D. Install and tighten hose clamps on each con-
nection.
5/32" TEE HOSE INTO
VACUUM LINE ATTACHED
TO THE FMU
ø
DISCHARGE
TUBE SUPERCHARGER
AIR INLET
DUCT
BYPASS VALVE V