Vortech 2000-2008 Honda S2000 - Manual (Page 25)

P/N: 4HS020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
21OCT08 v4.0 S2000(4HS020-010v4.0)
13
8. SUPERCHARGER MOUNTING BRACkET/PLATE INSTALLATION, cont’d
Fig. 8-e
DO NOT INSTALL HARDWARE
IN THIS HOLE AT THIS STEP
M12 x 1.75 x 50mm SCREW WITH
WASHER INSTALLED THROUGH
SUPPORT PLATE AND ¯1.0 x .549
SPACER AND INTO SUPERCHARGER
BOSS (SPACER SANDWICHED
BETWEEN CENTER SUPERCHARGER
BOSS AND SUPPORT PLATE)
3/8-16 x 1.25 SCREW
WITH A WASHER
3/8-24 x 3.5" SCREW/
BEARING PILOT
INSTALLED THROUGH
RIBBED IDLER AND
SPACER AND INTO
THE NUT INSTALLED
IN THE MAIN PLATE
(SEE SIDE VIEW)
BELT TENSIONER
ADJUSTMENT SCREW
AND LOCATOR BLOCK
(LOCATED ON OPPOSITE
SIDE OF PLATE) ATTACHED
WITH TWO 1/4-20 x .75
SH SCREWS THREADED
IN FROM THIS SIDE
OF MAIN PLATE
MAIN SUPERCHARGER
MOUNTING PLATE
1/2-20 BELT TENSIONER
ARBOR SCREW
INSTALLED (FROM
OTHER SIDE)
THROUGH MAIN
PLATE IDLER SPACER
SMOOTH IDLER - M12
x 10" THICK WASHER
AND 1/2-20 JAM LOCK
NUT (SEE SIDE VIEW)
GRAPHIC TWO
MAIN SUPERCHARGER MOUNTING PLATE
VIEW FROM BACKSIDE
(DASHED LINES REVEAL HIDDEN VIEWS)