Vortech 2000-2008 Honda S2000 - Manual (Page 46)

P/N: 4HS020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
21OCT08 v4.0 S2000(4HS020-010v4.0)
34
16. ELECTRONIC CONTROL BOX INSTALLATION,
cont’d (2000-2005 MODELS ONLY)
N. Connect the blue wire from the timing
controller to the blue wire leading to the
engine compartment.
O. Connect the blue/red wire from the tim-
ing controller to the blue wire leading to
the vehicle’s computer.
P. Cut the green wire (20 TDC1P) on the
31P connector and install one male and
one female slide connector onto each
end.
Q. Connect the green wire from the timing
controller to the green wire leading to
the engine compartment.
R. Connect the green/red wire from the tim-
ing controller to the green wire leading
to the vehicle’s computer.
S. Cut the yellow wire (29 TDC2P) on the
31P connector and install one male and
one female slide connector onto each
end.
T. Connect the yellow wire from the timing
controller to the yellow wire leading to
the engine compartment.
U. Connect the yellow/green wire from the
timing controller to the yellow wire lead-
ing to the vehicle’s computer.
V. Tap the yellow/black wire from the timing
controller into the blue (19 ned) wire on
the 32P connector.
W. Route the supplied vacuum line to the
rubber grommet that the vehicle’s com-
puter wires go out of. Punch a small
hole in the rubber grommet and push
NOTE: it does not matter which two red
and tan wires you use to signal the
supplement injector.
Fig. 16-d
Fig. 16-e
the vacuum line out through the hole.
X. Route the vacuum line up to the FMU
and connect into it using the provided
brass TEE.
Y. Connect the other end of the vacuum
line to the FTC with the provided plastic
vacuum line tap.
Z. (2004-2005 Models) There are four
injector plugs running from the control
box. Run one plug through the firewall to
the supplementary injector installed in
the charge cooler. Connect the plug to
the injector. (See Fig. 16-g.)
AA. (2004-2005 Models) Secure the remain-
ing injector wires.