Vortech 2000-2008 Honda S2000 - Manual (Page 37)

P/N: 4HS020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
21OCT08 v4.0 S2000(4HS020-010v4.0)
25
A. Locate the supplied charge cooler. Insert the
supplied 60 lb/hr fuel injector into the injector
base welded to the cooler discharge tube so
that the injector plug is facing away from the
injector base. (See Fig. 10-a.)
B. Insert the upper block over the injector.
Secure the upper injector block with the sup-
plied shoulder bolts.
C. Install the 1/8"NPT end of the supplied 90° fit-
ting into the upper injector block. Orient the
fitting so that it is pointing toward the back of
the car.
D. Connect the 90° end of the supplied steel
braided line to the -4 end on the installed
straight fitting in the fuel rail. Run the fuel line
toward the front of the car. Leave the open
end of the fuel line disconnected until the
charge cooler has been installed. (See Fig.
10-b.)
NOTE: lightly oil the o-rings on the injector for
easier installation.
NOTE: thread sealant is recommenced on all fit-
ting ends that have pipe threads.
10. SUPPLEMENTARY FUEL INjECTOR INSTALLATION (2004, 2005 MODELS ONLY)
Fig. 10-b
Fig. 10-a