Vortech 1994-2001 Acura Integra GSR - Manual (Page 15)

P/N: 4HC020-030
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN04v2.1(Acura Integra LS (4HC..030v2.1))
7
9. MAIN BRACKET INSTALLATION
A. (For Acura Integra GSR models, skip Step A and
proceed with Step B.) Bolt the supplied mounting
bracket spacer block to the front of the cylinder
head using the two supplied M10 x 35 bolts. (See
Fig. 9-a.) The spacer block is in the supercharger
mounting plate assembly.
B. Lower the supplied cast aluminum mounting
bracket assembly (w/driveshaft attached) in front
of the engine and push tightly against the ex-
haust manifold. Lower the power steering pump
between the mounting bracket and the vehicle
frame.
C. Each of the two lowest holes in the mounting
bracket require a supplied .304" spacer between
the mounting bracket and the block. (See
Fig. 9-
b.)
D. Install the two shortest factory power steering
bracket bolts and the two supplied M10 x 35 (LS
models use 3/8-16 x 1.0) bolts in each of the four
Fig. 9-b
8. POWER STEERING PLUMBING
A. Select the supplied pair of power steering
fittings that match the power steering pump
and the metal power steering tube. The correct
female fitting will fit snugly over the O-ring on
the power steering tube.
B. Install and lightly coat the O-ring onto the
supplied power steering pump fitting with
Honda power steering fluid and insert into the
power steering pump. Rotate fitting until the
bolt holes line up with the pump. Secure the
fitting to the power steering pump using the
supplied 6mm bolts and washers.
C. Attach the straight fitting end of the supplied
power steering hose to the just installed power
steering pump fitting and tighten. (See
Fig. 8-
a.)
Fig. 8-a
Fig. 9-a / LS Models Only
MTNG BRKT SPACER BLOCK