Vortech 1994-2001 Acura Integra GSR User Manual
Page 16
P/N: 4HC020-030
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN04v2.1(Acura Integra LS (4HC..030v2.1))
8
Fig. 9-c
Fig. 10-a
A. Remove the two bolts securing the bracket that
attaches the ground strap to the transmission
and set aside.
B. Remove the top three transmission to bell-
housing bolts. Leave the small steel bracket
fastened to the front of the engine by the lower
bolt.
Fig. 10-a shows how the supercharger
mounting plate attaches to the engine in
Section 11.
C. Remove the two bolts securing the clutch line
support to the engine mounted bracket. Re-
move the bracket from the clutch line.
D. The clutch tubing will need to be bent so as to
clear the supercharger when it is installed.
Bend the tubing as little as possible and avoid
kinking.
E.
Loosen the bracket/clamp holding the A/C
lines. Remove the bracket connected to the
frame. (See
Fig. 10-b.)
10. SUPERCHARGER MOUNTING PLATE PREPARATION
Fig. 10-b
mounting holes in the supplied mounting bracket.
Tighten to 33 ft/lbs (44 N-m).
E.
Install the supplied 2.25" idler pulley to the
mounting bracket. Make sure that the spacer
between the two idler pulley bearings slides over
the mounting bracket pilot, secure using the
supplied 5/16 x 1- 1/4" bolt and 5/16 washer.
(See
Fig. 9-c.)
F.
Loosely install the power steering pump using the
original bolts and tensioner screw.
9.
MAIN BRACKET INSTALLATION. cont’d.