Vortech 1994-2001 Acura Integra GSR - Manual (Page 20)

P/N: 4HC020-030
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN04v2.1(Acura Integra LS (4HC..030v2.1))
12
13. STANDARD KIT DISCHARGE DUCT INSTALLATION
A. Loosely install the supplied sleeves on both
ends of the supplied discharge duct. The
2-3/4" to 2-1/2" reducer sleeve should be
placed on the supercharger.
B. Put the discharge duct into position and slide
the sleeves onto the supercharger and the
throttle body.
C. Tighten the hose clamps on both ends of the
discharge duct.
Fig. 13-a / (GSR shown, others similar.)
Fig. 14-a / GSR inlet
14. AIR FILTER INSTALLATION
A. Drill a 5/16" hole in the end of the supplied air
filter.
B. Install the air filter on the supercharger inlet
and tighten the clamp.
C. Insert the supplied plastic elbow into the end of
the air filter and attach to the valve cover vent
with 3/8" hose.
NOTE: If a high-output kit (with charge air cooler) is
being installed, complete the steps included
in the “Maxflow Power Cooler Installation
Instructions” (P/N: 8N020-110) and then pro-
ceed with Step 14.