Vortech 1994-2001 Acura Integra GSR - Manual (Page 19)

P/N: 4HC020-030
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN04v2.1(Acura Integra LS (4HC..030v2.1))
11
12. RADIATOR HOSE AND WATER NECK INSTALLATION
A1. GSR and LS Models
1. Install the supplied water neck in place of
the removed factory water neck.
2. Replace the hose running from the bottom
of the throttle body to the engine block/
water neck with the supplied 5/16" hose.
Secure with the factory clamps.
3. Trim about 1" from the straight end of the
supplied radiator hose and install. (See Fig.
12-a.)
A2. Type R
1. Disconnect the upper radiator hose from
the radiator.
2. Trim about 1/2" from the longer straight end
of the supplied radiator hose.
3. Install the cut end of the supplied radiator
hose onto the radiator. Cut the factory
radiator hose as needed to connect to the
installed hose using the supplied hose
coupler.
4. Secure the hose coupler using the supplied
#24 hose clamps. Use the factory hose
clamp to secure the supplied radiator hose
to the radiator. (See
Fig. 12-b.)
B. If necessary for supercharger mounting plate
clearance, disconnect the lower radiator hose
from the radiator. Trim about 2" off and re-
install. Use the section of hose just removed to
protect the hose from any sharp or metal
objects.
Fig.12-a / GSR and Ls Models
Fig.12-b / Type R Model