Vortech 8-Rib Drive Upgrade for 2011-2012 Mustang GT - Manual (Page 4)

iv
P/N: 007130 v1.0, 2012-02-10
© 2012 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
This product may not be legal for use on public roads in all 50 states.
NOTICES
(Read before installation is started)
Included in this kit is an 8-rib supercharger pulley that may be smaller than the one origi-
nally supplied. This new pulley is recommended to achieve the best performance results.
Removal of the factory sealed pulley will reduce the supercharger warranty from three
years to one year unless the supercharger unit (with the original pulley still attached) and
new pulley are sent into Vortech for removal, installation and re-sealing. If the super-
charger warranty is not a concern or if the supercharger warranty has expired, the pulley
may simply be removed and replaced with the new part supplied. Hammering/prying etc.
on the supercharger and/or pulley will cause damage to the parts. Light heating of the
supercharger pulley with a propane torch (if the pulley is tight on the shaft) will aid remov-
al. A return authorization number is required before the supercharger and pulley are sent
into Vortech. Call the Vortech service department at (805) 247-0226 for a return authoriza-
tion number. Return freight (ground) will be paid by Vortech.
This product is protected by state common law, copyright and/or patent. All legal rights
therein are reserved. The design, layout, dimensions, geometry, and engineering fea-
tures shown in this product are the exclusive property of Vortech Engineering, Inc./
Paxton Automotive. This product may not be copied or duplicated in whole or part,
abstractly or fundamentally, intentionally or fortuitously, nor shall any design, dimension,
or other information be incorporated into any product or apparatus without prior written
consent of Vortech Engineering, Inc./Paxton Automotive.
• Custom ECM programming and fuel / ignition system upgrades will be required when
changing the supercharger drive pulley to any size other than what was originally
supplied in the complete supercharger kit.
• Supercharger pulley removal may reduce or void the supercharger unit warranty.
• Pulley Diameter Changes: Careful size selection is mandatory for proper engine and
supercharger longevity. Contact the applicable Vortech and Paxton tech line for assis-
tance with impeller speed calculations if necessary.
• A Vortech Maxflow Race or Mondo compressor bypass valve is required for applica-
tions producing more than 11-12 psig.
IMPORTANT