Vortech Maxflo Fuel Pump Booster (FPB) for 2011-2012 Mustang - Manual (Page 4)

DP/N: 007127v1.1, 2012-02-21
© 2012 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured. iv iv
VORTECH FUEL PUMP VOLTAGE BOOSTER
Installation Instructions
2011-2012 MUSTANG GT
Before beginning this installation,
please read through this entire instruction booklet
The Vortech 2011-2012 Mustang GT Fuel Pump Booster (FPB) upgrade was designed
specifically for use on 2011-2012 Ford Mustang GT vehicles equipped with a turbocharg-
er, supercharger or nitrous oxide, to support applications with increased horsepower
over the basic kit. As with any power enhancing product, this unit is intended for use on
healthy, well-maintained engines. Vortech Engineering is not responsible for engine
damage. Installation on new vehicles will not harm or adversely affect the break-in peri-
od so long as factory break-in procedures are followed.
For best performance and continued durability, please take a note of the following key
points:
1. Use only premium grade fuel 91 octane or higher (R+M/2).
2. Always listen for any sign of detonation (pinging) and discontinue hard use (no
boost) until problem is resolved.
TOOL & SUPPLY REQUIREMENTS:
• Open End Wrenches (5/16”, 10mm )
• 3/8” Ratchet
• 10mm, 13mm, and 5/16” Sockets
• Flat #2 Screwdriver
• Phillips #2 Screwdriver
• Utility Knife
• Heat Gun
• Soldering Iron/Gun
• Electrical Tape
• Wire Cutters, Strippers and Crimpers
• Drill Motor
• 1/8”, Drill Bit