Woodhaven 3220: Oval Jig - Manual (Page 2)

1
BEFORE BEGINNING
Identify and verify that you have all the parts listed. Read the
instructions at least once, familiarizing yourself with the parts before
beginning. You'll need a #2 & #3 Phillips screwdriver for assembly.
DETERMINE USE
The the Oval Jig Base must be mounted at one of three
different heights in relation to the top of the work: 1. Top of Oval
Jig Base at the same height as the top of the work. 2. Top of Oval
Jig Base 1/2" above the work. 3. Top of Oval Jig Base 1" above
the work. Keep in mind that the higher above the work you mount
the Oval Jig Base, the longer bit you’ll need to make the cut.
Option A: Oval Jig Base is mounted directly on (1/2" above)
the work, for example a solid table top. Or mount the Oval
Jig Base to a 1/2" plywood base (it will then be 1" above
the work) and then mount the plywood to the work.
Option B: Oval Jig Base (and/or plywood base) and
work are mounted on a bench and the work surrounds
the Oval Jig Base, for example a segmented open frame.
Oval Jig Base must be mounted either even with the top
of work, 1/2" above the work or 1" above the work.
ASSEMBLY
Mark the center of your work, or center the Oval Jig
Base on square piece of 1/2" plywood to serve as a base.
There are small center marks on each side of the Oval Jig
Base to help align it on the center of the work. Attach the
Oval Jig Base to the work/plywood base with 1" screws
(STP008). Slide a plastic glide of each pivot assembly (3220P)
in to each of the T-slots in the Oval Jig Base. See fig. 1.
A
B
1