Woodhaven 3220: Oval Jig - Manual (Page 3)

2
3
MOUNT ROUTER & ROUTER PLATE
Follow the directions in the 4973 Plate Hardware.
Install the hardware on the Router Plate (3200P) and adjust
it for your router, but don’t attach the router to the Router
Plate yet. We offer an optional drill-style plate (3200PD) that
can be drilled for a semi-permanent router mounting.
Cut two blocks of wood 2-3/4" long and lay the 24"
Double Track (4024l) on the two blocks as shown. Insert
two 3/4" screws (MF010) thru the two countersunk holes
nearest the opening in the Router Plate (3200P) and start
nuts (NUT015) on the ends of the screws. See fig. 2.
Slide the nuts in the router plate onto the end of the Double
Track until the end of the track is even with the opening in
the plate, then tighten the two screws firmly. See fig. 3.
If you mounted the Oval Jig Base even with
the top of the work, then you don’t use the plate
spacer and you can go on to the next section.
If you mounted the Oval Jig Base 1/2" above the
work, install the plate spacer (3200S) on the bottom of the
router plate using two 3/4" screws (MF010). See fig. 4.
If you mounted the Oval Jig Base 1" above the work,
install the plate spacer (3200S) on the bottom of the router
plate using two 1-1/4" screws (MF020) with two 1/4" spacers
(BUSH1250) placed on each screw between the plate spacer
and the router plate. This method will require a bit with a
longer cutting length then the other two methods above.
MOUNT DOUBLE TRACK/ROUTER PLATE
Install a washer (WB002) on the stud of two of the ratchet
handles (5863). Insert the stud of the ratchet handle thru the slot,
then the hole, in the aluminum bracket of each pivot assembly.
Start an oval nut (5760B) on the end of each stud. See fig. 1.
Slide the Double Track/Router Plate on to the
oval nuts of each pivot assembly and install your
router on the router plate. See cover, fig. 5.
2
4