Woodhaven 5432: HD Panel Master - Manual (Page 3)

Center the template side-to-side on the base. Install two 3"
bolts (HB060) thru the recessed slot in the bottom of the base, in
the holes that line up with the holes in the template. See fig. 6.
For Standard Door Templates: Place one 5/8" spacer
(BUSH004) on each bolt. The height of the spacer stack on
each bolt should be slightly more then the thickness of the
panel. Use the 1/8" & 1/4" spacers (BUSH001 & BUSH002 -
extras included) as needed to achieve this height. For example,
if you're panels are 5/8" thick, install a 1/8" spacer on top of
each 5/8" spacer for a total height of 3/4". Place a 1" washer
(WFN002) on each bolt/spacer stack. Install the template on the
bolts and another 1" washer on each bolt, on top of the template.
Place a knob (5560) on each bolt and tighten. See fig. 7.
For HD Door Templates: To start, place three 1/4"
spacers (BUSH1250 - extras included) on each bolt. The
height of the spacer stack on each bolt should be more then
the thickness of the panel. Use whatever 1/4" or 1/8" spacers
(BUSH1125 - extras included) are necessary to achieve
this height. For example, if you're using a 5/8" thick panel,
the three 1/4" spacers provide a height of 3/4" to clear the
panel. Next, make sure the template clears the shaper cutter
(flush or raised panel cutter) and that the shaper cutter
bearing is riding on the template. Stack as many additional
spacers as necessary to achieve the best template height
for your cutter and bearing. Place a 1" washer (WFN002)
on each bolt/spacer stack. Install the template on the bolts
and another 1" washer on each bolt, on top of the template.
Place a knob (5560) on each bolt and tighten. See fig. 8.
2
7
8
6
Select holes in base
that line up with
holes in template
BUSH004 &
BUSH001
BUSH1250 x 3