Denon AVR-2807 - Manual (Page 14)

10
Easy Setup Procedure Easy Setup Procedure
ENGLISH
ENGLISH
Press <ON/STANDBY> or [ON] .
• The power indicator blinks green and the power turns on.
Press <POWER> .
£ OFF:
The power turns off and the indicator is off.
¢ ON:
The power indicator lights red.
Turn on your subwoofer.
Set the volume to halfway and set the crossover frequency
to the maximum or Low pass filter off if your subwoofer can
adjust the output volume and the crossover frequency.
Some subwoofers have a standby mode. Be sure to turn
this function off before performing the Auto Setup
procedure.
Turn on your monitor.
w Before performing the Auto Setup
procedure
1
2
3
4
e Perform the Auto Setup procedure
Press D D H H to select “Auto Setup / Room EQ”,
then press ENTER .
Press SYSTEM SETUP .
Press D D H H to select “Auto Setup”, then press
ENTER .
The message “Connect Microphone” is displayed if no
microphone is connected. If so, connect the auto setup
microphone.
1
2
3
• “System Setup Menu” is not displayed when using
headphones.
1
2
3
r Assigning power amplifiers
Press D D H H to select “Power Amp Assign”, then press
F F G G to set.
The surround back output can be assigned to the “Front” or
“ZONE2” output.
Front A, Front B:
Assign to use the “Front A” (or “Front B”) speakers with bi-
amp connections.
Surround Back:
Assign to use as surround back speaker.
When assigned to “Front”, skip the surround back channel
measurement.
During the auto setup procedure, test tones are not output
to “ZONE2”.
ZONE2:
Assign to use as “ZONE2” speakers.
t Switching the front speaker
Press D D H H to select “Front Sp”, then press F F G G to
select the speaker.
Front A
Front A+B
Front B