Denon AVR-2807 - Manual (Page 39)

35
Basic Operation Basic Operation
ENGLISH
ENGLISH
Either turn <FUNCTION> or press [TUNER] to
select “TUNER”.
Auto tuning
Manual tuning
• When the manual tuning mode is set, FM stereo broadcasts are
received in monaural and the “STEREO” indicator turns off.
Press [MODE] to set the auto tuning mode.
• The “AUTO” indicator lights.
Press [TUNING] .
• Automatic searching begins.
• If tuning does not stop at the desired station, use to the
“Manual tuning” operation.
Listening to the radio
Check that the remote control unit is set to “AMP”.
Either turn <FUNCTION> or press [TUNER] to
select “TUNER”.
Press [MODE] to set the manual tuning mode.
Check that the display’s “AUTO” indicator turns off.
Press [BAND] to select “AM” or “FM”.
Press [BAND] to select “AM” or “FM”.
Press [TUNING] to tune in the desired station.
The frequency changes continuously when the button is
held in.
1
2
3
4
1
2
3
4
Use the “Auto tuning” or “Manual tuning”
operation to tune in the station to be preset in the
memory.
Press [MEMORY] .
Press [CHANNEL] to select the desired preset
channel (1 to 8).
Preset memory
Press [SHIFT] to select the desired memory block
(A to G).
Press [MEMORY] again.
• Store the station in the preset memory.
1
2
3
4
5
• To preset other channels, repeat steps 2 to 5.
A total of 56 broadcast stations can be preset — 8 stations
(channels 1 to 8) in each of blocks A to G.
• The memory block can also be selected by pressing [SHIFT].
Using the fader function
With this function, the volume of all the front side speakers or all
the rear side speakers can be adjusted (attenuated) at once.
Press CH SEL/ENTER .
Press D D H H or CH SEL/ENTER to select “Fader”.
Press F F to attenuate the volume of all the front
side speakers, G G to attenuate the volume of all the
rear side speakers.
The fader function does not affect the subwoofer.
It is possible to adjust so that the volume of the speaker
whose volume is the lowest is –12 dB.
1
2
3
2
3