Denon AVR-2807 User Manual

Page 7

Advertising
background image

3

Getting Started

Getting Started

ENGLISH

ENGLISH

Accessories

Check that the following parts are attached in addition to the
main unit:

q

Operating instructions ......................................................1

w

Service station list.............................................................1

e

Power supply cord (Approx. 1.5 m) ..................................1

r

Remote control unit (RC-1030) .........................................1

t

R6P/AA batteries ..............................................................3

y

AM loop antenna ..............................................................1

u

FM indoor antenna............................................................1

i

Setup microphone (DM-S205) (Approx. 6 m) ...................1

r

t

y

u

i

e

Before using

Pay attention to the following before using this unit:

• Moving the unit

To prevent short-circuits or damaged wires in the connection
cables, always unplug the power supply cord and disconnect
the connection cables between all other audio components
when moving the unit.

• Before turning the power switch on

Check once again that all connections are correct and that there
are not problems with the connection cables. Always set the
power switch to the standby position before connecting and
disconnecting connection cables.

• Store these instructions in a safe place.

After reading, store this instructions along with the warranty
card in a safe place.

• Whenever the power switch is in the STANDBY state, the

unit is still connected to AC line voltage.
Please be sure to turn off the power switch or unplug the
cord when you leave home for, say, a vacation.

• Note that the illustrations in these instructions may differ

from the actual unit for explanation purposes.

About the remote control unit

In addition to controlling the AVR-2807, the attached remote
control unit (RC-1030) can also be used to control the following
products:
q DENON component products
w Component products other than DENON:

• Set using the preset memory function (

page 62, 63).

• Set using the learning function (

page 64).

Cautions on installation

Wall

Note

Note:
For heat dispersal, do not install this unit in a confined space
such as a bookcase or similar enclosure.

Operating range of the remote control unit

30°

30°

Approx. 7 m

• Point the remote control unit at the remote sensor when

operating it.

• The remote control unit can be used from a distance of up to

about 7 meters, at a horizontal angle of up to 30° with respect
to the sensor.

NOTE:
• It may be difficult to operate the remote control unit if the

remote sensor is exposed to direct sunlight or strong
artificial light.

Inserting the batteries

q Remove the remote control

unit’s rear cover.

w Set 3 R6P/AA batteries in

the battery compartment in
the indicated direction.

e Put the rear cover back on.

Notes on batteries:
• Replace the batteries with new ones if the set does not

operate even when the remote control unit is operated
nearby the unit. (The attached batteries are only for verifying
operation.)

• When inserting the batteries, be sure to do so in the proper

direction, following the “<” and “>” marks in the battery
compartment.

• To prevent damage or leakage of battery fluid:

• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of

batteries in flames.

• Remove the batteries from the remote control unit when

you do not plan to use it for an extended period of time.

• If the battery fluid should leak, carefully wipe the fluid off the

inside of the battery compartment and insert new batteries.

• When replacing the batteries, have the new batteries ready

and insert them as quickly as possible.

Advertising