Engine coolant temperature gage, Safety belt reminders, Engine coolant – Pontiac 2010 Vibe User Manual

Page 93: Temperature gage -11, Safety belt reminders -11

Advertising
background image

that the fuel filler door is on the driver
side of the vehicle. The fuel gage
works only when the ignition switch is
turned to ON/RUN. When the gage
first indicates E or empty, there is still
about 2 gallons ( 7.6 L) of fuel left,
but more needs to be added right
away. When the vehicle is low on fuel
the low fuel warning light, located
below the empty mark, comes on.

Five things that do not indicate a
problem with the fuel gage:

At the gas station, the fuel pump
shuts off before the gage reads
F or full.

It takes a little more or less fuel
to fill up than the gage indicated.
For example, the gage may have
indicated the tank was half full,
but it actually took more or less
than half the tank’s capacity to
fill it.

It takes the gage several minutes
to read F or full after filling the
vehicle with fuel.

The gage moves a little when you
turn, stop or speed up.

The gage does not go back to E
or empty when you turn off the
ignition.

Engine Coolant
Temperature Gage

This gage shows the engine coolant
temperature. If the gage pointer
moves into the red area, the engine
is too hot. Pull off the road, stop the
vehicle, and turn off the engine as
soon as possible. See Engine
Overheating
on page 9-23.

Safety Belt Reminders

When the engine is started, a chime
will sound for several seconds to
remind people to fasten their safety
belts, unless the driver safety belt is
already buckled.

The safety belt light will also flash
until the driver belt is buckled. If the
driver belt is already buckled, neither
the chime nor the light comes on.

This light is located on the center
of the instrument panel, next
to the audio system.

When the key is turned to ON/RUN
or START, this light comes on
as a reminder for the right front
passenger to fasten their safety belt.

United States

Canada

Instruments and Controls

4-11

Advertising