Desa CGCDV42PR EN - Manual (Page 27)

www.desatech.com 116236-01G 27
6. Install rear brick panel first. Rest bottom edge
of panel on back edge of burner assembly (see
Figure 44).
7. Install left side brick panel by sliding it be-
tween the burner assembly and the side of the
firebox (see Figure 44).
8. Install the right brick panel using the same
method described in step 6 for left brick panel.
9. Replace deflector shield using screws removed
in step 4.
10. Using screws removed in step 4, replace
plenum and attach to burner.
11. Using screws removed in step 3, replace
log/grate assembly. Be careful when replac-
ing log/grate assembly not to chip logs on
burner.
12. Install lava rock and glowing embers. See
Installing Lava Rock and Glowing Embers,
page 26.
13. Close glass door and lock latches on top and
bottom of door and replace screen. See Remov-
ing Glass Door, steps 5 and 6 on page 25.
14. Close top and bottom louvers.
FIREPLACE
INSTALLATION
Continued
Figure 44 - Installing Rear Brick Panel
Rear Brick Panel
Left Side
Brick Panel
OPERATING FIREPLACE
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the gas
supplier's instructions.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. If the
knob will not push in or turn by hand,
don't try to repair it, call a qualified service
technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information
above.
2. Open lower louver panel.
3. Turn off all electric power to the fireplace.
4. Push in gas control knob slightly and turn
clockwise to OFF.
5. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow “B” in the
safety information above. If you don't smell
gas, go to the next step.
6. The pilot is located by the main burner and
should not require accessing for lighting.