Ryobi BTS20R-1 - Manual (Page 16)

Page 16
ASSEMBLY
OPENING THE LEG STAND
See Figure 9.
NOTE: You can also refer to the blue label on the right-hand
side of the table saw for setup procedures.

Standing to the front side of the table saw, use your left
hand to pull the leg stand latch towards you. See 1.
� Once the leg stand is released from the table saw base,
ease the legs of the leg stand toward the floor. See 2.
� Grasp the leg firmly with your right hand. Keeping your
left hand clear of the leg stand, pull the leg stand up until
it locks into place. See 3 and 4.
� With your left hand firmly on the table tilt handle, grasp
the leg with your right hand. See 5.
� Push the leg stand towards the ground with your right
hand and pull in the same direction with your left hand
until the table saw is in an upright position. See 6 and 7.
CLOSING THE LEG STAND
See Figure 9.
NOTE: You can also refer to the blue label on the top of the
table saw for tear-down procedures.
� Standing to the front side of the table saw, grasp the table
tilt handle with your left hand. Tilt the table saw to your
left and grab the leg with your right hand. Gently lower
the table saw on its side. See 1 and 2.
� With your right hand on the leg, use your left hand to
release the leg stand latch. See 3 and 4.
� Once the leg stand is released from the table saw base,
ease the legs of the leg stand toward the floor. See 5.
� Place your right hand palm up near the bumper and lift
the lower leg of the leg stand up until it locks into place.
See 6 and 7.
Fig. 9