Dell PowerConnect M6220 - Manual (Page 702)

700 Configuring IP Multicast
IGMP Proxy Interface Membership Info Detailed
Use the IGMP Proxy Interface Membership Info Detailed page to display detailed interface
membership data. You must have configured at least one router interface before you can display detailed
interface membership information, and it should not be an IGMP routing interface. Also, if no group
membership reports have been received on the selected interface you cannot display data.
To display the page, click IP Multicast > IGMP > Proxy Interface > Interface Membership Info
Detailed in the tree view.
Figure 12-33. IGMP Proxy Interface Membership Info Detailed
The IGMP Proxy Interface Membership Info Detailed page contains the following fields:
• Interface — Select the interface for which data is to be displayed.
• Multicast Group IP — Select the IP multicast group address for which data is to be displayed. If no
group membership reports have been received on the selected interface, you are not able to make this
selection, and none of the non-configurable data is displayed.
• Source IP — This parameter shows source addresses that are members of this multicast address.
• Last Reporter — The IP address of the source of the last membership report received for the selected
interface’s IP Multicast group address.
• Up Time (secs) — Displays the up time since the entry was created in the cache table.
•
State — The state of the host entry. A host can be in one of the following states:
–
Non-member State — Does not belong to the group on the interface.
– Delaying Member State — Host belongs to the group on the interface and report timer is running.
The report timer is used to send out the reports.
– Idle Member State — Host belongs to the group on the interface and no report timer is running.
• Filter Mode — The group filter mode (Include/Exclude/None) for the specified group on the IGMP
Proxy interface.