Dell PowerConnect M6220 - Manual (Page 135)

Configuring System Information 133
Out of Band Interface
Use the Out of Band Interface menu page to assign the Out of Band Interface IP address, the Subnet
Mask, the Default Gateway IP address, and to assign the boot protocol.
To display the Out of Band Interface page, click System > IP Addressing > Out of Band Interface in
the tree view.
Figure 6-24. Out of Band Interface
The Out of Band Interface page contains the following fields:
• Protocol — Use the drop-down menu to select None, Bootp, or DCHP.
•
IP Address — Displays the Out of Band Interface IP address.
• Network Mask — The subnet mask of the source IP address.
Note: Each part of the IP address must start with a number other than zero. For example, IP addresses
001.100.192.6 and 192.001.10.3 are not valid.
• Default Gateway — Sets the default gateway IP address.
• Burned in MAC Address — Displays the Burned in MAC Address of the Out of Band Interface.
Modifying Out of Band Interface IP Address Parameters
1. Open the Out of Band Interface page.
2. Modify the IP address in the IP Address field.
3. Modify other fields as needed.
4. Click Apply Changes.
The parameters are modified, and the device is updated.