5 installation, 1 control cabinet installation, 1 dimensions – Pilz PNOZ mm0p-T User Manual
Page 13: Section 5, Installation, Control cabinet installation, Dimensions
Installation
Operating Manual PNOZ mm0p-T
1002704-EN-01
13
Installation
Control cabinet installation
}
The unit should be installed in a control cabinet with a protection type of at least IP54.
}
Use the notch on the rear of the unit to attach it to a mounting rail.
}
In environments exposed to heavy vibration or when installing on a vertical mounting
rail (35 mm), the unit should be secured using a fixing element (e.g. retaining bracket or
end angle).
}
Push the unit upwards or downwards before lifting it from the mounting rail.
ATTENTION!
Damage due to electrostatic discharge!
Electrostatic discharge can damage components. Ensure against discharge
before touching the product, e.g. by touching an earthed, conductive surface
or by wearing an earthed armband.
Dimensions
*with spring-loaded terminals
120 (4.72")
* 100 (3,94")
98 (3.86")
45
(1.77")
5
5.1
5.1.1