Lenco CS-420 - Manual (Page 10)

10
OPERATION
- Error symbol on the display.
Note: if press RESET button (8), the unit
can’t work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.
RADIO OPERATION
 SWITCHING TO RADIO MODE
Press MOD button (2) to select radio
mode, the radio mode appears in the
display together with the memory band
and frequency.
 SELECTING THE FREQUENCY BAND
At radio mode, press BAND button (16)
shortly to select the desired band.
The reception band will change in the
following order:
→FM1→ FM2→ FM3
 SELECTING STATION
Press button (18) or button (1)
shortly to activate automatic seek
function. It will search up/down a
station automatically. Press for 2
seconds until “MANUAL” appears on
the display, the manual tuning mode is
selected. In this mode you can turn
up/down a step frequency one by one
till searched a station. If both buttons
have not been pressed for 5 seconds, it
will return to seek tuning mode and
“AUTO” appears on the display.
 AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic memory storing
Press AS/PS button (4) for several
seconds, the radio searches from the
87.5 MHz frequency and checks the
signal strength until one cycle search
is finished. And then some strong
stations are stored into the
corresponding preset number button.
- Program scanning
Press AS/PS button (4) shortly to
scan preset station. The radio is
holding at that preset number for
several seconds with release mute,
then searches again.
 MANUALLY STORING STATION AND
RECALL PRESET STATION
To receive a station, Press one of the
preset button(1~6) for 2 seconds. The
current station is stored into the number
button. Shortly press the preset button
(1~6) to directly listen the station that
saved in the corresponding preset
button.
RDS(RADIO DATA SYSTEM)
OPERATION
- Setting RDS mode
In AF item of the SEL menu. Rotating
the audio knob (3) to switch on or off the
AF function.
Whenever AF
is on, symbol “AF”
appears on the display.
Program name is displayed on receiving
a RDS station.
“AF” starts blinking if the broadcasting
signal getting worse.
“ALARM” will be displayed when an
emergency broadcasting is received,
meanwhile sound output level will be
adjusted to the preset output level
automatically when the volume control
is set at minimum.
- Regional Program Operation
When AF function is on. In REG item of
the SEL menu. Rotating the audio knob
(3) to switch on or off the region mode.
Some broadcasting stations change
their program from normal broadcasting
to regional broadcasting for a certain
time period. When region is on, the
current listening program remains