Lenco CS-420 - Manual (Page 12)

12
OPERATION
USB PLAY OPERATION
In the front panel of the unit, there is an
USB interface (6). You can connect an USB
driver through this interface (6).
When you connect an USB driver through
the interface, the unit will search the MP3
/WMA files in the USB driver and start to
play. If in other mode, you can also press
MOD button (2) to select USB mode. It
supports the MP3/WMA file in the device.
The operation please refer to the following
instruction.
SELECTING TRACKS
Press
button (1) or button (18) to
move to the previous file or the following file.
File number shows on display.
Hold
button (1) or button (18) to
fast reverse or fast forward. Playing starts
from when you release the button.
PAUSING PLAYING
Press
button (15) to pause playing.
Press it again to resume play.
PREVIEWING ALL FILES
Press INT button (14) to play first several
seconds of each file. Press again to stop
intro and resume play.
REPEATING THE SAME FILE
Press RPT button (13) to continuously
repeat the same file. Press it again to
repeat all the files.
PLAYING ALL FILES IN RANDOM
Press RDM button (12) to play all files in
random order. Press again to cancel the
function.
SELECTING DIRECTORY UP/DOWN
Press DIR-button (11) or DIR+ button (10)
to select directory downward or upward. If
the USB does not contain any directory,
there is no function of pressing DIR- button
(11) or DIR+ button (10).
SELECTING FILES BY AS/PS BUTTON
Press AS/PS button. It is activated the
“Search file number” mode. Rotating knob
(3) to select the file number then press
knob (3) to confirm. The unit searches the
selected file to play. You also can select the
file by following direct numeric buttons:
M1-M6: 1-6
BAND: 7
: 8
: 9
DISP: 0.
If the file number was selected. The unit
wait for knob (3) for seconds. The unit
searches the file after few seconds, even if
the knob (3) button is not pressed.
SD OPERATION
There is a SD interface (9) on the front
panel of the unit.
When you insert a SD card in the SD
interface, the unit will search the MP3 files
or WMA files in the card and start to play
automatically. The operation is the same
with the USB play operation described
above.
If in other mode, you can also press MOD
button (2) to select SD mode.
CAUTION：
When there are important files in the USB
Device or SD card, do not connect it to the
main unit to play, because any wrong
operation may cause files loss. And our
company assumes no responsibility for this.