Lenco CS-440 BT - Manual (Page 10)

9
3. Radio Operation
1. BAND BUTTON
In RADIO mode, press the BAND button on the remote control or
on the front panel to select your desired radio band of FM1, FM2,
FM3, AM1 and AM2, and the selected band will be displayed
on the small monitor of the front panel.
2. TUNE/SEEK UP/DOWN BUTTONS
In RADIO mode:
1) Press and hold the UP/DN button to automatically search
up/down for a available station from the current frequency.
2) Briefly press the UP/DN button to manually search up or down
with step by step for your desired station from the current frequency.
3. APS BUTTON
In RADIO mode:
1) When pressing and holding the APS button, the radio searches
from the lowest frequency and checks the signal strength level
until 1 cycle search is finished. And then the 6 strongest stations
are preset to the corresponding preset number memory bank. The
AS operation is implemented in each bank of the selected band. When the AS operation is finished,
the radio executes the preset scan, and after preset scanning for one cycle, it will stop scanning
and broadcasting the No.1 station for FM1.(It can store 3x6 stations for FM and 2x6 stations for AM in all)
2) When briefly pressing the APS button on the front panel or the remote control, the radio searches
for each preset station from the M1. When the field strength level is more than the threshold level
of the stop level, the radio holds at that preset number for few seconds with releasing mute, and
then searches again. After finishing a circle of searching, it will stop searching on the M1.
NOTE: In FM band, FM1,FM2,FM3 is checked one at a time.
In AM band, Am1, Am2 is checked one at a time.
4. PRESET STATION [ 1-6 ] BUTTONS
1) To memorize the current frequency on the current band, press and hold any one of the six
Number buttons (1-6) .
2) To recall the memory station on the current band, press one of the Number buttons [1-6] .
5. STEREO/MONO BUTTON
Press the ST button on the remote control to select the STEREO or MONO sound mode for FM band.
6. LOC BUTTON
1) When the signal of the distance radio station are very weak and the receiving effect is bad during
tuning, check whether there is the word LOC on LCD. If there is the word LOC on LCD, press this
button to turn off the LOC function, then tune again for the distance radio station;
2) When the signals from the local radio stations are too strong, this could lead to interference.
press this button to turn on the LOC function, and the LOC icon will be lit up on the LCD.
Re-tune for the local station required.
7. PTY (PROGRAM TYPE) BUTTON
Press the PTY button shortly to select one of the following mode:
PTY MUSIC group- - PTY SPEECH group- - PTY OFF
When PTY group is on, rotate the VOL knob or press the + or the - button to select one of PTY programs:
<-->NEWS<-->AFFAIRS<-->INFO<-->SPORT
<-->EDUCATE<-->DRAMA<-->CULTURE <-->SCIENCE<--> VARIED<-->
WEATHER<-->FINANCE<-->CHILDREN<-->SOCIAL<-->RELIGION<-->
PHONE IN<-->TRAVEL<-->LEISURE<-->DOCUMENT< -->PTY NONE<-->
RADIO interface
AUDIO & VIDEO SETUP interface