Lenco PA-1500 - Manual (Page 7)

7
System installation
The Lenco PA-1500 is an ALL-IN-ONE ready to use audio system. Simply place
the Lenco PA-1500 on a straight and solid surface.
1. Check if the power ON/OFF switch (number 3 in Fig. 2) is in OFF position.
If not, you need to turn the switch in OFF position.
2. Depending on the country where you are using the unit you need to switch
the voltage selector (number 2 in Fig. 2) between AC range 100~120V AC
60Hz or 220~230V AC 50Hz
3. Connect the power cable to the unit and AC outlet (number 1 in Fig. 2 or
to Fig. 3).
Note: Here you find a built in fuse, if it is damaged you can replace it with a fuse that has
the same specifications, see chapter replacing the fuse.
4. Connect the microphone stand to the main unit and plug the microphone
in the MIC1 connection (Fig. 3).
5. Place the power ON/OFF switch in ON position. Now the unit is ready for
use!
Fig. 2
Fig. 3