Lenco SCD-1000 - Manual (Page 5)

GB-8 GB-9
CASSETTE OPERATION
PAUSE BUTTON
Press this button to pause cassette playback.
STOP/EJECT BUTTON
Press this button to stop cassette playback and again to eject the cassette door.
F.FWD BUTTON
Press this button to advance rapidly during cassette playback or stop mode.
REW BUTTON
Press this button to go backward rapidly during cassette playback or stop mode.
PLAY BUTTON
Press this button to begin cassette playback.
IMPORTANT SAFETY INSTRUCTIONS
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
When the mains plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable. To be completely disconnected the power input, the mains plug
of the apparatus or the appliance coupler shall be disconnected from the mains completely.
No naked flame sources, such as lighted candles, should be placed on the apparatus.
Minimum distances 2.0cm around the apparatus for sufficient ventilation. The ventilation should not
be impeded by covering the ventilation openings with items, such as newspapers, table-cloths,
curtains, etc.
The use of apparatus is in tropical and/or moderate climates.
Attention should be drawn to the environmental aspects of battery disposal.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
The marking plate is located at the back of the apparatus.
SPECIFICATION
GENERAL
Power requirement .......................... AC 100-240V 50/60Hz
(YOUR EXACT AC POWER CAN BE CHECKED
FROM THE BACK PLATE OF UNIT.)
DC 12V UM-1/”D”x8pcs
Power consumption ......................... 23 W
Dimensions ...................................... Approx. 391mm(L) x 211mm(W) x 186mm(H)
Operation temperature ..................... +5ºC ~ + 35ºC
RECEIVER SECTION
Receiving bands .............................. FM
Tuning range .................................... FM 87.5 - 108.0 MHz
CD PLAYER SECTION
Playback system .............................. Compact Disc Digital Audio System
CASSETTE SECTION
Frequency response ........................ 125-6300 Hz
AUDIO SECTION
Power output ................................... Maximum 8 Watts per channel
Speaker impedance ......................... 8 ohms
Specifications are subject to change without notice.
SERVICE AND SUPPORT
For information: www.lenco.com
For support: http://lencosupport.zendesk.com
Lenco helpdesk:
Germany
0900-1520530 (Local charges)
The Netherlands 0900-23553626 (Local charges + 1ct p/min)
Belgium 02-6200115 (Local charges)
France 03-81484280 (Local charges)
The helpdesk is accessible from Monday till Friday from 9 AM till 6 PM.
When contacting Lenco, you will always be asked for the model and serial number of your product. The
serial number can be found on the back of the device. Please write down the serial number below:
Model:SCD-1000
Serial number:_________________________________
Lenco offers service and warranty in accordance to European law, which means that in case of repairs
(both during and after the warranty period) you should contact your local dealer.
Important note: It is not possible to send products that need repairs to Lenco directly.
Important note: If this unit is opened or accessed by a non-official service center in any way, the
warranty expires.
This device is not suitable for professional use. In case of professional use, all warranty obligations of
the manufacturer will be voided.
This symbol indicates that the relevant electrical product or battery should not be disposed
of as general household waste in Europe. To ensure the correct waste treatment of the
product and battery, please dispose them in accordance to any applicable local laws of
requirement for disposal of electrical equipment or batteries. In so doing, you will help to
conserve natural resources and improve standards of environmental protection in treatment
and disposal of electrical waste (Waste Electrical and Electronic Equipment Directive).
Products with the CE marking comply with the EMC Directive (2004/108/EC) and the
Low Voltage Directive (2006/95/EC) issued by the Commission of the European
Community.
The declaration of conformity may be consulted at
http://www.lenco.eu/supportfiles/CE/kljagfo8q74y5086o8q7tr.pdf
®All rights reserved