Lenco XEMIO-261 - Manual (Page 16)

3. Push Next to select “Replay”.
4. Press Mode to enter Replay.
“A” flickers in Replay Mode icon and start point is to be set.
5. Push Next to set “A”.
After “A” set, “B” flickers in icon , and endpoint B needs to be set.
6. Push Next to set “B”.
Replay icon is fixed and A-B segment replay begins. When replay times count up to times set in
advance, the player will quit from Replay Mode. At Replay Mode, pushing Pre can set “A” again to select
another segment. (Setting of replay times refers to “Replay Times” in the next section.
○ Follow Read (This function does not exist at Voice Mode)
1. Replaying A- B segment, Push Next to enter Follow Read Mode.
2. Replay icon changes to Follow Read icon , and record sound of users is recorded. The
recording time is as long as A- B segments.
3. After recording time, the icon changes to , and original sound is played. Push Next button to enter
Comparison.
 At this mode, pushing Last button may return to A-B Replay Mode.
○ Comparison (This function does not exist at Voice Mode)
1. Enter this mode, Replay icon changes to and the recorded sound of users is played.
2. After playing the recorded sound, the icon changes to , and original sound is played
3. After playing the or iginal sound, the recorded sound is played again. The whole procedure will not stop
(without limitation by Replay Times) until press Mode to exit.
 At this mode pushing Pre may return to Follow Read Mode.
 At the three modes above, pressing Mode may exit from Replay Mode directly.
 Replay Times (Play Submenu)
Operating steps refer to Backlight setting.
Replay times mean that after A-B segment has been replayed up to fixed times, it will exit from Replay
Mode.
 Replay Gap (Play Submenu)
Operating steps refer to Backlight setting.