Altera MAX V CPLD - Manual (Page 13)

January 2011 Altera Corporation MAX V CPLD Development Kit User Guide
4. Development Board Setup
The instructions in this chapter explain how to set up the MAX V CPLD development
board.
Setting Up the Board
To prepare and apply power to the board, follow these steps:
1. Ensure that the shunt jumper for J8 (connecting pins 9 and 10) is set to 3.3 V
(default setting).
2. To power up the board, plug in the USB cable to the host PC, and plug the other
end of USB cable into the board USB type B connector (J4). No other power supply
is needed.
When the board is powered up, the blue LED power indicator will illuminate.
1 It is also possible to power up the board through the BATT+ and BATT- connectors
using three 1.5-V batteries in series. However, once you plug in a USB cable, the board
disconnects the battery supply and obtains power from the USB cable.