TOYOTA 2011 Sienna User Manual
Page 717
659
4-3. Do-it-yourself maintenance
4
Mainten
ance an
d ca
re
■
After a fuse is replaced
●
If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (
●
If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■
If there is an overload in the circuit
The fuses are designed to blow before the entire wiring harness is damaged.
CAUTION
■
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury.
●
Never use a fuse of a higher amperage rating than that indicated, or use
any other object in place of a fuse.
●
Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.
●
Do not modify the fuses or fuse boxes.
NOTICE
■
Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer as soon as possible.