NISSAN 2009 Sentra User Manual

Page 47

Advertising
background image

6. Remove any additional slack from the seat

belt; press downward and rearward firmly in
the center of the child restraint with your
knee to compress the vehicle seat cushion
and seatback while pulling up on the seat
belt.

7. If the child restraint is equipped with a top

tether strap, route the top tether strap and
secure the tether strap to the tether anchor
point (rear seat installation only). See “Top
tether strap child restraint” in this section.
Do not install child restraints that require the
use of a top tether strap to seating positions
that do not have a top tether anchor.

8. After attaching the child restraint, test it be-

fore you place the child in it. Push it from side
to side while holding the seat near the seat
belt path. The child restraint should not
move more than 1 inch (25 mm), from side to
side. Try to tug it forward and check to see if
the belt holds the restraint in place. If the
restraint is not secure, tighten the belt as
necessary, or put the restraint in another
seat and test it again. You may need to try a
different child restraint. Not all child re-
straints fit in all types of vehicles.

9. Check that the retractor is in the ALR mode

by trying to pull more seat belt out of the
retractor. If you cannot pull any more belt
webbing out of the retractor, the retractor is
in the ALR mode.

10. Check to make sure the child restraint is

properly secured prior to each use. If the
seat belt is not locked, repeat steps 3
through 8.

Front-facing – step 6

WRS0681

Front-facing – step 7

WRS0698

Safety—Seats, seat belts and supplemental restraint system

1-31

REVIEW COPY—

2009 Sentra (sen)

Owners Manual—USA_English (nna)
10/23/08—debbie

Advertising