Optoma S313 - Manual (Page 35)

EN-35
enhanced image, adjust toward the maximum setting. For a smoother, more
natural image, adjust toward the minimum setting.
Color Temp.
If set to cold temperature, the image looks more blue. (cold image)
If set to medium temperature, the image maintains normal colorings for
white.
If set to warm temperature, the image looks more red. (warm image)
Color Settings
Press / /“Enter” key to enter the next menu as below and then use / /
/ key to select color. Press “Enter” to finalize the selection.
„ Red/Green/Blue/Cyan/Magenta/Yellow/White: Use / to toggle Hue/
Saturation/Gain and then use / to adjust the value.
„ Reset: Choose “Yes” to return the factory default settings for color
adjustments.
Color Space
Select an appropriate color matrix type from AUTO, RGB or YUV.
Signal
„ Automatic: Automatically selects the singal. If you use this function, the
Phase, frequency items are grayed out, and if Signal is not automatic,
the phase, frequency items will appear for user to manually tune and
saved in settings after that for next time projector turns off and on again.
„
Phase: Synchronize the signal timing of the display with the graphic
card. If the image appears to be unstable or flickers, use this function to
correct it.
„ Frequency: Change the display data frequency to match the frequency
of your computer’s graphic card. Use this function only if the image
appears to flicker vertically.
„ H. Position: Adjust the image left or right within the projection area.
„ V. Position: Adjust the image up or down within the projection area.
Reset