Appendices – Optoma W401 User Manual
Page 66
66
English
Appendices
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the “ ” button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Unscrew the two screws on the cover. 1
5. Lift up and remove the cover. 2
6. Unscrew the two screws on the lamp module. 3
7. Lift up the lamp handle and remove the lamp module slowly and carefully. 4
To replace the lamp module, reverse the previous steps.
8. Turn on the projector and use “Lamp Reset” after the lamp module is
replaced.
Lamp Reset: (i) Press “Menu” (ii) Select “OPTIONS” (iii) Select
“Lamp Settings” (iv) Select “Lamp Reset” (v) Select “Yes”.
The screws on the
lamp cover and the
lamp cannot be
removed.
The projector cannot
be turned on if the
lamp cover has not
been placed back on
the projector.
Do not touch the glass
area of the lamp. Hand
oil can cause the lamp
to shatter. Use a dry
cloth to clean the lamp
module if it was ac-
cidentally touched.
1
2
3
4