Belt pack transmitter – MIPRO act707se_ii(2ce158)c User Manual

Page 8

Advertising
background image

1 2

13

1

2

3

5

8

7

4

6

9

10

A C T

1. PARTS NAMES AND FUNCTIONS

(Fig.1)

(Fig.2)

9.

Battery Compartment and Cover: Accommodates one 9 Volt battery.

10. Detachable Belt Clip: Allows 360 degrees rotating to suit transmitting

angles. To detach simply use a screwdriver at a 45 degree angle to
unfasten. see diagram.

2. OPERATING INSTRUCTIONS

1.

To adjust GT/MT Switch (8), and Gain Control (7), simply push down both
snap locks on the sides of battery cover and flip it backwards to expose
the adjustment panel.

2.

Before power on, ascertain if same channel was set up for both receiver
and microphone. If not adjust to same channel accordingly.

3.

The LED indicator flashes briefly when power on indicating normal battery
status. If no flash occurs it has either no battery, the battery is drained or
installed incorrectly. Change accordingly.

4.

Plug the microphone connector into the input jack (1) and tighten the
connector screw by clockwise direction as shown in (Fig. 2).

1.

AF Input Jack: Connects to either lavaliere or headset microphone. (See
5 ways of connection on AF Input Connections)

2.

Power Switch: Switch to ON position for operation. Switch to OFF position
when not in use.

3.

Battery Status Indicator: Indicates the power on / off and battery status.
(a) When power switch is turned on: The LED indicator flashes briefly,
indicating normal battery status.
(b) When RED light illuminates at either power on or during usage: The
battery level is low, therefore, a new battery replacement is thus
necessary.

4.

Transmitting Antenna: 1/ 4

transmitting antenna.

5.

Transmitter Housing: Packages the PCB and battery.

6.

ACT Signal Receptor: Receiving ACT signal and adjusting frequency
automatically.

7.

Gain Control: Adjusts the desirous input gain.

8.

GT/MT Level Select Switch: Switch GT position for electric guitar usage
and "Line In". Gain Control is irrelevant for "GT". Switch to "MT" for
condenser microphone or wired microphone. Gain Control works in "MT"
for input sensitivity adjusting.

λ

Lavalier

Headset

Pleaseaimof
the fillister
andinsertthe
connector

CapsuleConnector

1

3

4

2

BELT PACK TRANSMITTER

BELT PACK TRANSMITTER

Advertising