Tascam X-48 - Manual (Page 40)

Recorder
Undo/Redo
Unlike tape machines, you can undo a recording pass and then put it back with redo.
Undo/redo is only available from the mouse/keyboard interface.
Mouse/Keyboard Operation (only)
•
Click the Edit menu and choose Undo or press Control-Z on the keyboard.
Metering
Several metering parameters are available:
•
Peak Hold displays the highest signal level achieved, either for a few seconds or
until cleared.
• Meters can be Pre-fader or Post-fader (not applicable in Mixer Bypass mode). This
means that the meters show the signal level either before or after the signal hits the
mixer interface.
• (GUI only) you can View Masters to see the signal level for the group and aux
channels.
Mouse/Keyboard Operation
• Click on the Meter button if meters are not displayed at the top of the
screen.
• Click on the Options menu and select the Meters submenu. From this submenu you
can select Peak Hold and Clear Overloads.
• Click on Options > Meters > Mode to select Pre-Fader or Post-Fader metering.
• Click on Options > Meters > View Masters to see the group and aux master levels, or
click on the on-screen meters themselves.
• To set the amount of time that peak values stay on the meters, click Windows and
select Settings. Click on the Prefs tab and change the Clear Overloads pulldown to
change the interval to 1 second, 5 seconds, 30 seconds or Hold (infinite).
GUI Meter Display
You can display the meters by clicking the bargraph icon in the center of the screen
or by pressing 1 on the keyboard.
Front Panel Operation
• Press
the PREF button and scroll to the Meters sub-menu and press CHNG.
40