Applied Motion BLuAC5-Si User Manual
Bluac5-si
Advertising
Table of contents
Document Outline
- Introduction
- Block Diagram
- Getting Started
- Status & Error Display LEDs
- Serial Comm Tx & Rx LED
- Bus voltage indication LED
- Seven Segment Display Error codes
- Seven Segment Display Status codes
- Regeneration LED
- Connecting to the PC using RS-232
- RJ11 Port
- Serial Programming Cable
- Connecting to a host using RS-485
- Getting and Connecting an RS-485 4-wire adaptor to your PC
- Getting and Connecting an RS-485 2-wire adaptor to your PC
- Before you connect the servo drive to your system
- Connecting the AC Power Input
- 24 Volt Controller Input (Keep Alive)
- Connecting Single Phase AC input (90-260VAC)
- Connecting 3-Phase AC input (90-260VAC)
- Connecting the Motor
- Recommended Ferrite Core Instructions
- Fuses - External and Internal
- Line Filters
- Connecting the Encoder & Hall Sensors
- Encoder Pinout
- Connecting a Single-Ended Encoder
- Connecting Single-Ended Hall Sensors
- Connecting Input Signals
- IN/OUT 1
- IN/OUT 2
- IN/OUT 1
- Connector Pin Diagram
- IN/OUT 2
- Connector Pin Diagram
- High Speed Digital Inputs
- 12-24V Single Ended Inputs
- What is COM?
- User Out 24V supply
- Digital Input Connection Examples
- Programmable Outputs
- Digital Output Connection Examples
- Recommended Motors
- Alpha A Series
- M Series
- N Series
- J Series
- Other Supplier’s Motors
- Setting Drive Current Limits
- What is “Peak Current Limit”?
- Using DC Brushed Motors
- Servo Drive Regeneration
- Wiring Integral Holding Brakes
- Mounting the Drive
- Mechanical Outline
- Technical Specifications
- Mating Connectors and Accessories