Desa CGCF10PR - Manual (Page 21)

www.desatech.com 112462-01C 21
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
Remote-Ready Models Only
(GHRCB Series & GHRCTB Series)
Installing Receiver
1. Disconnect jumper wire from control valve
(see Figure 27).
2. Locate battery clip mounted on back of re-
ceiver (see Figure 28).
3. Slide 9-volt battery (not included) through
clip.
4. Attach terminal wires to battery (see Figure 29).
5. Connect wires from remote receiver to con-
trol valve as shown in Figure 29.
6. Install remote receiver unit onto remote/
blower bracket using screws provided (see
Figure 29).
INSTALLATION
Continued
Figure 29 - Installing Remote Receiver
Remote
Receiver
Figure 27 - Disconnecting Wires From
Control Valve
Figure 28 - Attaching Battery to Receiver
Battery Clip
9-Volt
Battery
Receiver
Terminal
Wires
Control
Valve
Jumper
Wire
White Wire
to TH
Terminal on
Control
Valve
Red Wire to
TPTH
Terminal on
Control Valve
Installing 9-Volt Battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote con-
trol unit.
2. Attach terminal wires to the battery (not in-
cluded). Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
Figure 30 - Installing Battery in Hand-
Held Remote Control Unit (GHRCB and
CGHRCB Series)
Battery Cover
9-Volt Battery
Terminal
Wires
Remote
Control
Unit
Battery
Housing
Figure 31 - Installing Battery in Hand-
Held Remote Control Unit (GHRCTB and
CGHRCTB Series)
Remote
Control Unit
Battery
Cover
Terminal
Wires
9-Volt
Battery
Battery
Housing