CRU DataPAK - Manual (Page 8)

DataPAK - Manual
Page 8
4.1.1.1 Windows Installation
If you’ve chosen the Windows version of Configurator 3.0, a Setup Wizard will appear
on your screen. Click “Next”. After you click “Next” it will take you to a licensed
agreement for installing this software. Read over the agreement and select “I accept
the agreement”, then click “Next”. The Setup Wizard will automatically create folders
for Configurator. If you would like to install it in a different folder on your system that’s
acceptable, just click “Browse” and select a new location. Once you’ve decided on where
to store the software click “Next”. Shortcuts will automatically be installed in the Start
Menu under a subfolder called CRU-DataPort. Again, if you’d like to install this in a
different area select “Browse” and choose a different location. After you’ve decided on
where to store the program’s shortcuts click “Next”. Then you can opt to have a desktop
icon installed. Make your selection and click “Next”. After that the wizard will prompt
you to install the software and will give a brief recap of the different selections you
have made. Click “Install” and let the wizard complete your installation. Finally, you can
choose to launch the Configurator now. Click “Finish” and open up Configurator 3.0.
4.1.1.2 Mac Installation
If you’ve chosen the version of Configurator 3.0, a License Agreement will appear on your
screen. You can select “Agree” and run Configurator straight from the source, or you can
select “Save” and save the software to your Mac. CRU-DataPort recommends saving it to
your Mac as well as placing an icon on your desktop for future use.
4.1.2 RAID Setup - Using Configurator 3.0
Open Configurator 3.0. A reminder will appear
telling you to disconnect all other USB and
FireWire devices. Be sure to do that and then
select “Continue”. If configuring a RAID you’ll need
to have your drives loaded inside of the unit. When
Configurator 3.0 appears you can power on your
DataPAK.